serial wire viewer

[tstalcup]

Are there any tools readily available to use the SWV functionality for PSoC3, or is this still roll your own at this point? I can't seem to find much for the cypress parts - plenty for ARM based chips, but I'm not sure that really helps here.

[mgs]

Unfortunately we do not have support for that in PSoC Creator yet. We hope to have added it by the end of the year. It will support both PSoC 3 and PSoC 5 parts.

-- mgs

[TKMstr]

Hello,

does this mean that it is not possible to make use SWV interface before this function is implemented in the Creator?
I want to use the interface to output data via UART protocol over the pin.

I have used the description in the TRM but it doesn´t work.
Is there somewhere an example or a more detailed explanation how to use the SWV interface?

Regards, TK

[mgs]

Unfortunately, SWV is not supported in PSoC Creator and so is also not available through the MiniProg3 yet. I cannot think of an alternative I am afraid.

-- mgs

[TKMstr]

Ok, thanks for reply! But I did not quite understand .So far I don´t use SWV and I did not know much about it.
My question is whether if it is possible to use SWV even without the Creator or MiniProg?

By that I mean to activate the interface in firmware and output the debug data on the SWV-pin? Or is it currently not usable at all?

Greetz, TK