10 pin MiniProg 3 connector

[wolfc]

I need some information on the 10 pin JTAG connector used with MiniProg3. I've been looking for some documentation on it but I haven't found any. I need to know the pin spacing and the width the pins of the pins. by placing a standard DIP package next to it appears there are 2 pins for every 1 on the dip package. This would make the pin spacing 50mils. Is this correct?

If someone has a link to something they know works I would appreciate it.

If the pin spacing is 50mils these are the options I found

http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=S9085-ND
I found this similar connector on digikey but I think it needs a cut out on one of the long sides (the connectors on the programming wire have a little section that sticks out.)

http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=S9015E-05-ND
This option is just pins, the only issues i see with this one are the pins width and the possibility of connecting the programmer rotated 180 degrees.

[wolfc]

I finally found the documentation I was looking for.

http://www.cypress.com/?rID=38578