CY3276-ADCINCVR+PLT PSoC5 designer

This forum focuses on questions and issues with the Cypress PSoC Programmer software and Misc. PSoC Tools

Moderator: ericb

CY3276-ADCINCVR+PLT PSoC5 designer

Postby axbastian » Tue Dec 07, 2010 4:34 pm

Hi,

I am currently trying to use PLT and ADCINCVR modules at the same time. There are still some ports left after PLT been assigned, however input of ADCINCVR couldn't be assigned from the other available ports. Do you know how to assign the spare port into the ADCINCVR?
The picture attached below is what i am facing now. Input that i need to asssign is Port_0_7 but the ADC itself proposed different input as shown in the diagram while Port_0_7 is not in used.

Your help and reply is much much appreciated.



Thanks,



Alex
Attachments
PLT+ADC.JPG
axbastian
Newbie
Newbie
 
Posts: 2
Joined: Tue Dec 07, 2010 4:24 pm

Re: CY3276-ADCINCVR+PLT PSoC5 designer

Postby axbastian » Fri Dec 10, 2010 5:03 am

I found a solution for that, just use an amplifier and take input from other available ports.
axbastian
Newbie
Newbie
 
Posts: 2
Joined: Tue Dec 07, 2010 4:24 pm


Return to “%s” PSoC Programmer & Misc. Cypress Tools

Who is online

Users browsing this forum: No registered users and 1 guest

cron