Which Programmer for CY8C24123A?

Questions about programming (not codeing) PSoCs and Encore II as well as freeware programming hardware and software are discussed here. This is also the place to talk about production programming. Programming means loading a HEX file in to the Flash, not, writing your program.

Moderator: ericb

Which Programmer for CY8C24123A?

Postby cJo » Tue Apr 30, 2013 2:01 pm

Hi
I want to program PSoC CY8C24123A microcontroler with CY3271-FTPC (PSoC FirstTouch Starter Kit with Low Power RF). Is it possible or should i use another programmer device?
cJo
Newbie
Newbie
 
Posts: 7
Joined: Tue Apr 30, 2013 1:46 pm

Re: Which Programmer for CY8C24123A?

Postby danadak » Wed May 01, 2013 2:46 am

Yes, you can can do pass thru programming, as you are probably aware
the expansion boards you plug into the USB host end of the kit can be
programmed, as well as the host end itself.

Or just use a Miniprog 3.

Regards, Dana.
Field Application Engineer
KB1RHB Mostly listen :)
Semi Retired
User avatar
danadak
The Big Cheese
The Big Cheese
 
Posts: 2008
Joined: Thu Dec 27, 2007 8:42 am
Location: New Hampshire

Re: Which Programmer for CY8C24123A?

Postby cJo » Wed May 01, 2013 3:25 am

On my circuit board Vcc requires 5V, however; Vcc pin on the female expansion port of FTPC is 3.3V. Could it be a problem? Do you know what is the value of Vcc in Miniprog?
cJo
Newbie
Newbie
 
Posts: 7
Joined: Tue Apr 30, 2013 1:46 pm

Re: Which Programmer for CY8C24123A?

Postby danadak » Wed May 01, 2013 5:51 am

This should help, user manual -

http://www.cypress.com/?rID=38154

1.2 Programming

The MiniProg3 programmer/debugger provides the flexibility to work with different programming and
debugging interfaces, such as JTAG, SWD, ISSP, and I2C. MiniProg3 supports all 8-bit and 32-bit
PSoC devices. When programming, MiniProg3 enables communication with target devices using I/O
voltage levels from 1.5 V to 5.5 V. In addition, MiniProg3 can supply power to a simple target board
at one of four voltage levels: 1.8 V, 2.5 V, 3.3 V, or 5 V.


Regards, Dana.
Field Application Engineer
KB1RHB Mostly listen :)
Semi Retired
User avatar
danadak
The Big Cheese
The Big Cheese
 
Posts: 2008
Joined: Thu Dec 27, 2007 8:42 am
Location: New Hampshire


Return to “%s” Device Programmers

Who is online

Users browsing this forum: No registered users and 1 guest

cron