I`m a beginner

Questions about programming (not codeing) PSoCs and Encore II as well as freeware programming hardware and software are discussed here. This is also the place to talk about production programming. Programming means loading a HEX file in to the Flash, not, writing your program.

Moderator: ericb

I`m a beginner

Postby antolavoro » Thu Aug 25, 2011 11:47 am

Hi at All, i`m a beginner of PSOC and i`ve some difficult.
I need to realized a simple code but I don`t know where i must start..... ( panic....)
I want to use the CY8C21123-24SXI for chage a pwm frequency and duty cycle.

the code specifications is:

1) read two analog input from ( 0 to 5 vdc)
2) if change the analog input 1 the signal frequency change from 0Hz to 200Hz
3) if change the analog input 2 the signal duty cycle change from 1 to 100%.

Can i`ve a help?

very thanks, Antonio
Posts: 2
Joined: Sat Oct 30, 2010 10:26 pm

Re: I`m a beginner

Postby chardroyston » Sun Aug 26, 2012 11:02 pm

Posts: 1
Joined: Sun Aug 26, 2012 10:30 pm

Re: I`m a beginner

Postby bobmarlowe » Tue Aug 28, 2012 2:12 am

Welcome in the fascinating world of PSoCs!
We all bave been beginners, so take it like Arthur Dent: "Don't Panic"!

To help you better: What equipment do you already have?
Do you own any development kit? In the case you do not have got a Kit-001, have you got an ICE-Cube?

PSoC1 (normally) does not have provisions for de-bugging and since it is VERY difficult to look into the chip you will need some provisions to watch your programmed chip.
Development kits usualy come with an easy-to-use 2-line LCD.

To make a long story short: I strongly suggest you to buy you a development kit for your project to start with.

If you have already programmed in C you will not have problems realizing your project.

User avatar
The Big Cheese
The Big Cheese
Posts: 1490
Joined: Thu Oct 06, 2011 2:03 am
Location: Germany

Return to “%s” Device Programmers

Who is online

Users browsing this forum: No registered users and 1 guest