miniprog3 not working

Questions about programming (not codeing) PSoCs and Encore II as well as freeware programming hardware and software are discussed here. This is also the place to talk about production programming. Programming means loading a HEX file in to the Flash, not, writing your program.

Moderator: ericb

miniprog3 not working

Postby vidya » Thu Dec 15, 2011 3:49 am

Hello All,

Our miniprog3 was working fine and then there was a power cut after which the programmer refuses to find the target .
It gives a message that no devices are connected.
Can anybody shed light on whats happening?

Can we get the programmer rectified somewhere in india ?

Thanks in advance.

Posts: 1
Joined: Thu Dec 15, 2011 1:39 am

Return to “%s” Device Programmers

Who is online

Users browsing this forum: No registered users and 1 guest