Eval Board Program fails up this day

[opsoc]

Hi,

starting today, I get errors on programming the PSoC5. The Device is recognized (CY8C5588) but than I get Unkown Device Errors with different Device IDs, e.g. 0x69, 0x00, 0x01, 0x13x069, 0xffffffff.

What happened here? I did restart my PC, Update the Programmer, restart the board, USB Programmer ... I'm using the latest PSoC Creator 1.

[danadak]

The latest Creator is 2.0. Also make sure the correct device is selected,
including engr rev level. In release notes there is a discussion of past
engr devices no longer supported by Creator.

Regards, Dana.

[opsoc]

a new PSOC board works, probably the old one is gone. BTW, how often I can flash the PSoC?

[bobmarlowe]

Flash can be made 50.000 times, that is 3 years, if you flash every hour, 24 hours a day including sundays.

Bob