problem to connect MiniProg3

This forum focuses on questions and issues with the Cypress PSoC Programmer software and Misc. PSoC Tools

Moderator: ericb

problem to connect MiniProg3

Postby elganor » Fri Feb 15, 2013 4:51 am

Hello everyone,
I just bought a Miniprog3 and I can't have it been recognized with PSoC Programmer. I installed the last driver and associated softwares but when I try to connect it with PSoC Programmer, there is the message I've got :

| Select Port in the PortList, then try to connect
Failed Connect to MiniProg3/1216DD000981 at 13:31:43
| SetLedState(...) failed in MiniProg3
Opening Port at 13:31:38|

and the red indicator still red with "not connected" write on it.

Does someone know what this is about?
I'm not sure if it means something but when I connect the Miniprog3 in the USB port, all LEDs blink once and Windows (which is windows seven 64bits by the way) recognizes the hardware this is about.
The problem is critical, I have to use it this week end and I don't know what to do ; I didn't find anything related on the forum.
Thank you
Posts: 4
Joined: Tue Jun 09, 2009 7:46 am

Re: problem to connect MiniProg3

Postby bobmarlowe » Fri Feb 15, 2013 9:28 am

I never used the Miniprog3 together with the Programmer.
Are you connecting to a PSoC1 3 or 5 device?
Did you connect the MP3 :mrgreen: to your target vis SSP connector or are you using the ribbon-cable and connect to SWD?
User avatar
The Big Cheese
The Big Cheese
Posts: 1490
Joined: Thu Oct 06, 2011 2:03 am
Location: Germany

Re: problem to connect MiniProg3

Postby danadak » Fri Feb 15, 2013 7:37 pm

Win 7 not yet supported, but folks have gotten drivers installed -

Miniprog3 also has had some revs -

Regards, Dana.
Field Application Engineer
KB1RHB Mostly listen :)
Semi Retired
User avatar
The Big Cheese
The Big Cheese
Posts: 2008
Joined: Thu Dec 27, 2007 8:42 am
Location: New Hampshire

Return to “%s” PSoC Programmer & Misc. Cypress Tools

Who is online

Users browsing this forum: No registered users and 0 guests